A super deep depth of field camera that imaging from an oblique position

Even if imaging from an oblique with a normal camera like a visual inspection, it can focus only part of the image, the image has a sense of perspective and it is not suitable for inspection. The breakthrough camera developed by ViSCO, the super deep depth of field camera realizes high-precision inspection with high-definition images that focus on the entire surfaces.

The super deep depth of field camera has realized the strength of visual inspection
1. Clearly imaging defects such as scratches and irregularities
By imaging from the oblique, the shadow of the defect is made by the positive reflection light and it produces a high contrast. This makes it easy to confirm defect and the irregularity that were difficult to see in the image directly above.

2．Possible to inspect the part not seen by the image taken from the directly above.
Complex shapes that are hard to see from directly above are also obvious from an oblique angle. Reliably possible to image the part you want to inspect.

3．Three-sided simultaneous imaging stereoscopic inspection is possible
By a single imaging, possible to obtain a fine image of three surfaces, and possible to inspect accurately with fewer cameras and fewer imaging times. No need to prepare cameras and lighting on the number of surfaces to inspect. Therefore, for the entire inspection work, possible to expect speeding up and more cost savings.

Realize simplified equipment design and improved installation flexibility
Not necessary to worry about camera installation position, even if it cannot be set right above or right beside the inspection object. The super deep depth of field camera can be placed without interfering with the conveying unit.

Usage example of the super deep depth of field camera
The super deep depth of field camera is available for a variety of inspections such as:
● 3-D inspection of 3-sided simultaneous imaging of resin molded products
● TP inspection and width inspection of press-fit terminals
● Gap inspection of connector fitting part
● Detecting connector pin tip
● Inspection of scratches on the inner wall surfaces of large molded products
● Inspection of the integral resin molded part on the lead frame
● Robot alignment